JGRCADD Centre's newly acquired products from RAM CaddSys Pvt. Ltd. (2003.12.08)

StrucTools Software Suite

StrucTools software Suite is widely used software for the design of Structural Components. StrucTools Suite consists of the following modules.

StrucWall

• Designs structural wall sections for gravity, wind, and seismic loads
• Designs wall section for axial load, flexure, and shear
• Checks special detailing of wall & boundary element
• Computes and displays P-M capacity curve
• Conforms to ACI 318-02, ACI 318-99, IBC 2000, and UBC 97

sFooter

• Analysis and design of rectangular isolated and continuous wall footings
• Designs for flexure and gives full reinforcement detail
• Checks soil pressure, one-way shear, and two-way (punching) shear
• Conforms to ACI 318-02, ACI 318-99, UBC 97, and IBC 2000
• Fast and accurate solution

rWall

• Analysis and design of retaining wall systems
• Checks system stability against sliding and overturning
• Designs wall and base and gives full reinforcement detail
• Conforms to ACI 318-02, ACI 318-99, UBC 97, and IBC 2000

·         Surcharge loads and top-of-wall loads

PvsM

• Computes section capacity (interaction) diagram and checks section adequacy to carry loads (P, Mx, My)
• Reinforced and prestressed solid or hollow sections
• Conforms to ACI 318-99, ACI 318-02, IBC 2000, and AASHTO-98
• ACI 318-02 using the new Unified Design method
• Compares diagrams of different sections graphically
• Accurate and fast biaxial solution

Punch

• Punching shear analysis for columns or loaded areas
• Rectangular, round, and L-shaped interior, edge, or corner columns
• Slab openings around column
• Conforms to ACI 318-02, ACI 318-99, and IBC 2000  
• Fast and accurate solution considering biaxial moments

For more information please visit: www.structools.com or email: jopat@jgrcadd.com